Ideally suited for festivals, concerts and outdoor events, or any scenario needing to deal with inclement or unpredictable weather, the iSpiider® is a bright, high-performance rated WashBeam luminaire, retaining all the favourite features of its phenomenally successful indoor relative, the Spiider®.

Designed, developed, and manufactured, to be sealed against water and particle ingress, thereby strictly adhering to their IP65 rating, you can be confident of both its protection and performance.

Their aluminium housing gives a dust-free environment for the optics, eliminating the need for frequent cleaning and routine maintenance.

By including NFC (Near-Field Communication) technology, you can access setup, diagnostic and performance features, even when the fixture is not powered, directly from your mobile device using the Robe Com app.

iSpiider® uses the same 18 x 40-Watt, and 1 x 60-Watt LED source as the original, with the identical 12.5:1 zoom optical system, giving the same, tight 4° Beam to wide 50° Wash.

The unique Robe patented MCFE™ - Multi-Coloured Flower Effect, driven by the center 60W RGBW LED multichip, produces sharp, multicoloured spikes of light, rotating in both directions at variable speed, adding visual impact to any show.

All control protocols are present, with dynamic video effects achieved by mapping individual pixels, controlled by DMX control desks, media servers via sACN with internal HTP merging, or Kling-Net.

Designed to be used indoors or out, we make fixture swap with the original Spiider® easy, as the DMX control channels, operating speeds, and feature set of both luminaires are identical.

iSeries – Robe reliability in all weathers.

Light source

1x 60W RGBW and 18x 40W RGBW LED multichips

Light output

13.100 lm, 49.000 lx @ 5m

Zoom range

4° - 50°

Effects

pixel control, MCFE™ - Multi-Coloured Flower Effects (patented), virtual colour wheel, tungsten lamp effect, preprogrammed pixel effects

Innovations

DataSwatch™ – inbuilt virtual colour library

The DataSwatch™ inbuilt virtual colour library for Robe LED fixtures provides consistent colour rendering with commonly matched filter ranges, allowing for rapid and accurate programming.

MCFE™ – Multi Coloured Flower Effect

The Robe patented MCFE™ – Multi-Coloured Flower Effect – creates sharp, multi-coloured spikes of light, that are fully rotatable in both directions, at variable speeds.

EMS™ – Electronic Motion Stabiliser

The Robe EMS™ (Electronic Motion Stabiliser) system is a technology for precise Pan and Tilt movements, which reduces vibrations from audio outputs, truss movement and sprung or suspended floors.

RLCT™ – Robe lens coating technology

Just like with spectacles, our lens coating technology protects soft plastic lenses against surface scratches, that can even occur during cleaning when scrubbed repeatedly. Anti-static properties prevent dust build-up on the lenses, thus extending the period between maintenance cleaning.

L3™ – Low Light Linearity System

The L3™ Low Light Linearity System produces imperceptible, ultra-smooth fades to black.

GDTF – General Device Type Format

The General Device Type Format creates a unified definition for exchange of data for the operation of intelligent luminaries, such as moving lights. The file format is human readable and developed using open source formats.

Tungsten Emulation

When selected, the luminaire will mimic the colour temperature of a tungsten lamp as you lower the output to produce that classic warm glow.

QVGA Robe Touch Screen Display System

The QVGA Robe touch screen display gives full access to all fixture setup and diagnostic functions and is very intuitive to navigate.

FW diffusers for pixelated washers

Robe fixtures homogenise beams really well but, for the ultimate smoothness, most of our pixelated LED wash lights can easily be fitted with a Fresnel Wash (FW) diffusion filter in-between the LED array and the lenses. They can also be ordered pre-installed if desired, as FW versions.

Epass™

Robe lighting’s Epass™ provides Ethernet in/out connections with a pass-through switch that sustains Ethernet integrity when the fixture has no power to automatically maintain network connectivity.

REAP™ – Robe Ethernet Access Portal

The Robe Ethernet Access Portal allows to access internal data from a networked fixture, viewed as a web page, addressable via the fixtures network IP.

RAINS™ – Robe Automatic Ingress Protection System

The highly advanced patented RAINS™ (Robe Automatic Ingress Protection System) technology not only prevents ingress. It actively manages a fixture's internal microclimate removing internal moisture build-up caused by constant heating and cooling to provide maximum protection for electronics, revolutionising how outdoor fixtures are managed and protected.

POLAR+™

Outdoor fixtures need to operate in extreme cold. Therefore, Robe iSeries™ fixtures contain an innovative POLAR+™ technology - a special standby mode with low power consumption, in which the fixture's sensors and communications channels continue to function.

Robe NFC controller and app

The Robe COM application is an app based on NFC (Near Field Communication). It can be used to access to fixture’s settings of our NFC-based navigation display systems as well as reading out data of our TE™ Transferable Engines.

Product Video

Technical Specification

Expand AllDownload PDFCollapse All

Source

Light source type: 1x 60W RGBW and 18x 40W RGBW LED multichips

LED life expectancy: min. 50.000 hours

Typical lumen maintenance: L70/B50 @ 50.000 hours

Optical system

Dynamic Effects and Features

Colour mixing mode RGBW or CMY

Individual control of each RGBW pixel

White light: Variable CCT 2.700K - 8.000K

DataSwatch™ filters: pre-programmed 66 colours and tones including most used whites 2.700K, 3.200K, 4.200K, 5.600K and 8.000K

Tungsten lamp effect: 750W, 1.000W, 1.200W, 2.000W, 2.500W lamp emulation for whites from 2.700K to 4.200K (red shift and thermal delay)

Colour rainbow effect with variable speed

MCFE™ - Multi-Coloured Flower Effects – creating spectacular multicolour beam effects in the air rotating in both directions at variable speed (patented)

Pre-programmed pixel effects with colour, dimming and strobe chases, waves and pulses at variable speed and direction

Innovative Flower Effect: rotating in both directions at variable speed (Patented)

Electronic strobe effect with variable speed up to 20 Hz, pre-programmed random strobe & pulse effects

High resolution electronic dimming: 0 - 100%

L3™ - (Low Light Linearity) Imperceptible 18 bit dimming for ultra smooth fade to black

POLAR+™ for power saving and instant operation in extremely cold weather conditions

Control and programming

Setting & Addressing: ROBE Navigation System 2 (RNS2)

Display: QVGA Robe screen with battery backup, gravitation sensor for auto screen positioning, operation memory service log with RTC, built-in analyser for easy fault finding, NFC app controller

Protocols: USITT DMX-512, RDM, Art-Net, MA Net, MA Net2, sACN, Kling-Net

Wireless CRMX™ technology from Lumen Radio

Epass™: Ethernet pass through switch which sustains Ethernet integrity, when the fixture has no power, to automatically maintain network connectivity

REAP™ - Robe Ethernet Access Portal

RAINS™ (Robe Automatic Ingress Neutralization System) manages humidity, temperature and pressure control using an active monitoring system to automatically remove any moisture detected within the fixture and provides constant monitoring to ensure peak performance

DMX Protocol modes: 10

Control channels: 49, 27, 33, 90, 27, 47, 91, 110, 104, 123

Pan & Tilt resolution: 16 bit

R,G,B,W colour mixing: 8 or 16 bit (internal 18 bit)

Zoom: 8 bit

Dimmer: 8 or 16 bit (internal 18 bit)

Movement

Thermal specification

Electrical specification and connections

Approvals

Mechanical specification

Rigging

Included items

Optional accessories

Legal

Related News

4.3.2025

Robe Gets Close to the Edge with $UICIDEBOY$

Critically acclaimed and popular underground rap duo $UICIDEBOY$ completed their GREYDAY2024 US and Canadian tour with a production design – lighting and set – created by Ian MacDonald, who used Robe moving lights to help deliver a raw, in-the-face, lighting aesthetic.

28.2.2025

Robe Helps New Year’s Eve Live: Nashville’s Big Bash Go Large

Nashville – well known as a vibrant and major hub for the production and live entertainment industry – staged its own superlative concert – “Jack Daniel’s New Year’s Eve Live: Nashville’s Big Bash” – at Bicentennial Capitol Mall State Park to celebrate the new year rollover, featuring an impressive artist lineup and an eye-popping lighting and production design created by Robert W. Peterson of Real World Lighting.

28.1.2025

Robe Helps Lift the Mask in South Africa

The second series of The Masked Singer SA was one of the most successful music TV shows of 2024, broadcast on SABC, and featuring an outstanding production lighting design created by two of the country’s most talented LDs, Ryan Lombard and Joshua Cutts, based around the core components of 150 Robe moving lights.

8.11.2024

Robe at Lollapalooza Berlin 2024

Over 500 Robe moving lights were supplied by three top German rental and technical production companies to four main stages at the 2024 Lollapalooza Berlin festival, organised by Live Nation and staged over two days at the Olympiastadion (Olympic Stadium), proving once again that Robe is a powerful, reliable and weatherproof choice for outdoor events needing quality production lighting.